6 - Pasta Maker
5.3
Plug in the appliance, turn the speed selector to your
desired setting, we suggest you choose 3-5 setting, when the
appliance operates normally, put the food pieces into vegetable
tube, then press the food pusher to the lowest position.
Note:
1.
Do not operate the unit for more than 1 minute
continuously or the food should be no more than 0.5kg for
each use.
2.
During the appliance working, please don’t take off the
vegetable tube assembly from the motor unit.
5.4
Place a clean container with proper size under cutting tube
cover to receive food coming from the appliance.
5.5
When finish using, press the switch to “OFF” position,
unplug the power source.
5.6
Recommend function recipe
Recipe: Peel off potato, carrot or other fruits/vegetables, cut
into strips less than 45mm*45mm in size.
Method: operate unit for 1 min ON and then 1 min OFF at speed
setting 3-4, Add food into feed tube all the time and also press
down rod pusher with 90N force. Food to be processed every
time shall not exceed 0.5Kg.
Result: food shall be cut into slices or strips without blockage,
food slices or strips shall be uniform, shredding or slicing blades
shall not be damaged, it is acceptable a bit amount of food
remains within cutting tube.
Slicing
blade cone
Coarse shredding
blade cone
Fine shredding
blade cone
1. Lay the appliance on the flat horizontal surface and make
sure it is unplugged.
2. Prepare the following ingredients, and then assemble the
dough hook well in position by following the operaiton of
“
USING YOUR MIXER
”. After it, put oil, water, salt and bread
flour into the bowl.
1) Bread flour: 400g
2) Water: 160g
3) Salt: 3g
4) Oil: 5g
3. Make dough by following the operation as below: firstly, run
the appliance under speed setting 1 for 30 seconds and then
run it under speed setting 2 for about 4.5 minutes.
4. After making the dough, divide it into small pieces with a size
of 2.5cm*2.5cm*5cm.
5. Select the appropriate mould according to your requirement
and assemble the selected mould into the noodle-making
attachment well in position. There are 6 moulds attached for
making various noodles.
6. Open the Front cover (1), and then put the noodle-
making attachment into the low speed outlet and rotate it
anticlockwise until it is locked in position.
7. Assemble noodle making accessory, turn the speed selector
to setting 4 or 5. Make the dough into long strips, then put
them into feeding tube, test each noodle mould in 200g
dough, the unit can make noodle continuously without
blocking within 3mins, and the noodles are smooth, it means
pass the test.
The rest time for the unit after changing noodle mould can’t be
less than 15mins.
GB-20
GB-21
