Mandik MONZUN VULCAN, Installation And Operation Instruction Manual

Page: 20 / 52

EN
VULCAN REGULATOR | Instalation, operation instractions and maintenance manual
20
|
SETTING OF THE RDG 160 T ROOM
THERMOSTAT
Current time and week day setting
Press the button of time program setting
(middle one), the display shows the symbol
, confirm with the right button . Num-
bers showing the time start blinking, turn the
wheel and set the current time.
In order to change the time display format
from 24 hours format to the 12 hours one and
vice versa override the value 23:59, i.e. 00:00,
when setting the time.
Confirm the set time with right button ,
the week day indicator starts blinking, set the cur-
rent day by turning the wheel anticlockwise.
Confirm the set day with right button . Above
the left button, the symbol (Esc), is shown,
by pressing the left button you exit the pro-
gramming mode.
Note.: In case of power supply breach the time
starts blinking to indicate the power supply
failure. The time program continues with origi-
nal time before the power supply failure.
Time program setting (change)
The room thermostat includes 8 programma-
ble time blocks that can be assigned to one or
more week days.
1. Push twice the programming button
(middle one) in order to enter in time block
setting, this symbol shows .
2. Turn the wheel to choose the time block
A1…A8 you wish to set and confirm with
right button .
3. Turn the wheel and set the comfort mode
start and confirm with the right
button .
4. Turn the wheel to set the end of the com-
fort = start of the attenuation mode
and confirm with right button .
5. Symbols of week day 1, ok and Esc
starts blinking. Push the button ok in
order to insert or Esc not to insert the
time block in that day.
6. As soon as the block is/is not inserted into
the seventh day, all chosen week days start
blinking. Confirm the setting by the button
ok and thus you pass to setting of
another time block.
In order to save your setting do not forget to
push ok following the step 6 before you press
the button Esc to exit the programming mode.