Ref.: MEL-WA(3D HCV) - OM Ver.1.7
41
7. OPERATION
Only permit qualified & trained personnel to operate, maintain or repair the Aligner
Ensure the Top plate of Rotary plates are locked with Locking pins before parking the
vehicle. Always use rotary plate spacer for proper Runout measurement.
Always comply with the applicable accident prevention regulations
Avoid exhaust smoke directly falling on the Target plates
Do not hammers or hit any part of the equipment with service Tools
Do not operate the equipment under direct sunlight. Even reflected sunlight reaching
the camera will result in errors
Air blowing equipments like Pedestal Fan should not be in the close proximity of
Camera assembly as it will disturb the camera path affect the reading stability
Handle the Target plate carefully. Rough handling / shocks may cause damage to the
Target plates
7.1.
DEFECTS / MALFUNCTIONS
In case of defects or malfunctions such as etc., turn OFF the mains and
contact qualified Service personnel
7.2.
PRELIMINARY ALIGNMENT PREPARATION
The Bottom Camera is located in the Vertical column to measure the
parameters of wheels positioned upto 7mtr distance from Camera and the Top
Camera is located to measure the parameters of wheels positioned between
7mtr & 19mtr distance from Camera
By default, the system will support the adjustment of Axle position with
reference to Geometric center line. To switch over to Frame based alignment,
select “
Frame Measurement
”
from the “Model configurations” option in
Settings
screen (Refer Chapter 8.5 in Service manual)
7mtr
12mtr
19mtr
Top Camera
Bottom
Camera
1
st
Rotary
plate
2
nd
Rotary
plate
