Commissioning and operation
24
Operation monitoring system
Caution:
Do not exceed the maximum permissible engine tilt. If faults occur, find their cause immediately
and have them eliminated in order to prevent more serious damage!
If an engine / gearbox alarm is displayed on the monitoring devices, the engine is to be turned off
or, i.e. operated at low load at max. 1200 rpm.
When the following alarms are displayed
-
engine oil pressure / reduction of lubrication oil pressure
-
engine coolant temperature / overheating of engine coolant
-
engine charge-air temperature
the engine is to be turned off immediately and the cause of the fault properly remedied, i.e. in a
specialist workshop.
Do not put this engine into operation again until the fault has been eliminated.
The engine is equipped as series standard with a monitoring and diagnostic system
M
AN-
M
arine-
D
ia
gnose-
S
ystem (MMDS.
On the control console and alternatively on other control consoles, the following display devices are avail
able for monitoring operation:
1. Engine room panel, see page
CAN bus-controlled display devices:
2. CAN-Bus round instruments, see page 29
3. Display device MMDS-CLC 6.5, see page 33
4. MMDS-CLC 6.5 ship's alarm display, see page 48
Display units supported by PC:
5. Display device MMDS-CMS, see page 55
For operation and speed adjustment, MAN provides the following equipment:
6. Drive lever control system
M
arine
P
ower
C
6.1.
Mobile navigating console, see page 88
7. Optional: emergency unit Em (Emergency), see page 92
7.1.
Override button for MMDS-CR and MMDS-BE3 systems, see page 96
