- 4
–
Fit ‘O’ ring ( item 13 ) over pipe in boiler and locate bronze spring ( item 29 ) on top of ‘O’ ring.
Place grey fibre washer ( item 50 ) over dome bush thread ( item 30 ) and screw into boiler, with
spanner or adjustable, do tighten BUT DO NOT OVERTIGHTEN.
Fit dome ( item 31 ) by pressing from side against spring.
Fit washer ( item 34 ) onto safety valve ( item 35 ) and secure, finger tight, again oiling washer to
soften.
Locate burner tray under frames inside cab.
Finally fit grab rails to rear cab back.
Locate back ( item 43 ) into slots in back of cab and roof clip.
AS A FINAL CHECK
1. Oil all moving parts piston rods, port faces, reverse lever, wheel bearings and bushes.
2. Make sure all screws and nuts are tight.
3. Revolve wheels with palms of hand to make sure everything is in order.
WELL DONE !
/Continued on page 5
Summary of Contents for SL1K
Page 1: ...Mamod SL1K Locomotive Assembly Instructions ...
Page 7: ... 6 Continued on page 7 ...
Page 8: ... 7 ...
