Loading the Film Holder
Pull out the upper and lower Back Cover
Latches and the back cover will open. Be-
cause of the double safety lock, pulling out
just one of the two Back Cover Latches will
not open the cover. After opening the back
cover of the Roll Film Holder, remove the
Film Insert. When loading film, it is not nec-
essary to remove the holder from the cam-
era back. When loading film, avoid direct
sunlight--either load in the shade or turn
your body away from the sun and use the
shade of your own body.
While holding down the left-hand Spool
Release Pin of the Film Insert, fit a roll of film
between the upper and lower left-hand Film
Spool Studs. Make sure that the backing pa-
per is set as shown in the photo above.
When loaded correctly, the inside of the
backing paper (the black side) will appear on
the outside of the insert back. If it does not,
remove the film, turn it upside-down, and
reload .
After feeding the tip of the backing paper
into the slot of the Take-up Spool,
24
