13
SIP Settings:
You will find all settings relating to SIP here.
There are 4 sections altogether.
SIP Account Settings:
In this section
“User ID”
,
“Displayname”
,
“Phone Number”
and
“Domain”
can be
set. If
“Displayname”
as well as “Phone Number” are set, the
“Displayname”
will be
used for registration on the PBX.
SIP Register Settings:
There are two parameters for setting the PBX IP. This is the IP address which the
telephone registers at. The parameter
“Backup PBX”
is only used however if
“PBX
Alternation enabled”
is selected further down on the webpage
.
With
“SIP Port”
a port
can be set between 5.000 and 31.000 for the SIP connection.
“Register Attempts”
specifies the number of registration attempts before the
telephone gives up trying to register. A value of zero corresponds to an infinite number
of attempts.
“Register Timeout”
indicates the time in seconds that passes after each
failed attempt before the telephone makes another attempt. With
“Qualify
Connection”
is used to define a certain time span until the InduTel IP monitors if a
previously established PBX connection still existed.
SIP Features:
“Speed Dial”
activates the feature of the same name (see Operation) and can be
combined with
“Call Transfer”
.
“PBX Alternation”
activates permanent switching
between the two given PBX IP addresses after a certain number of failed registration
attempts (see
“Register Attempts”
).
If registration at one of the two PBX IP addresses was successful, the InduTel IP will
monitor this connection. If the connection breaks down, the procedure of permanent
alternation will restart until one of the two PBXs can be reached again.
www.malux.se
