1
PSR Rotolift + Autolid Controller setup
v1 Bulid 2020-07
Your new R Autolid Control Box has many new features and posisbilities , comparing to other Sabaj Lifts.
Please read this manual before you start programming the lift to your preferences.
Default settings : Every delivered lift is set by default to max left and right rotation , and max up and down
movement. The RF remote attached is also already paired with the Control box. To reset all the settings or
change the remote – please read the reset section in this document.
Setup Mode and Memory mode : Please note that the lift has 2 levels of setup. The first is acquired by
pressing&holding the setup button , and is signalized by a RED SETUP LED light. To enter the motion setup –
press RC-SET button. You will hear short beeping sounds when in Motion setup mode – this is normal , and
acquiring the certain motion limit ( I.E. max left rotation ) will result as a proper digital display symbol . The full
table of symbols is also attached in this manual.
Troubleshooting : The table of symbols on the digital display should also be used as a troubleshooting guide.
Always check , if the green POWER led light is on – this signals , that the control box is powered . When you put
the plug to the socket, you will hear the beeper sound , and the green led will be turned on. If the LED is not on
,the problem might be with the control box fuse breakdown , or there is no power in the socket.
RF Remote : Every control box with RF function is delivered with a pre-progammed RF Remote . Only Sabaj RF
remotes can operate with Sabaj Control boxes. The control box can store up to 8 different remotes.
SETUP led light ( red)
Power led light ( green)
Digital Display
