MALTEC ML2.240, Operating Manual

Page: 20 / 24

1. Never operate unit without water.
2. Pressure washer is not meant to pump
hot water. Never connect to hot water
supply – this will significantly reduce life
of the pump.
3. Using detergent other than others brand
may cause damage to pump components
(o - rings, etc.).This also applies to
chemicals
such as bleach, dish soap, etc.
4. Never operate unit for more than one
(1)
minute without spraying water. Resulting
heat buildup will damage pump.
5. Before adjusting nozzle’s pressure
(high - to - low or low - to - high) release trigger.
Failure to do so will reduce life of o - rings
in
lance.
MAJOR TECHNICAL DATA
ITEM ML2.240
Working pressure 10MPa(100 bar)
Allowable pressure 15MPa(150 bar)
Working flow rate 6.0 l/min
Max. flow rate 7.5 l/min
Max. pressure water supply 0.4MPa(4 bar)
Motor Capacity 2000W
Power Supply Voltage 230V~50Hz
Max. Water Temperature
50
℃
ELECTRICAL DIAGRAM
19