Malsch IMPULSE KL, Instruction Manual

Page: 34 / 64

34 |
Pos. 4
Pos. 3
VGS side rails adjustment
Vertically retractable split side rails
In standby position, the side rails are located next to the sleeping
surface. In this position, they prevent the mattress from slipping.
1. To raise the side rails, pull them upwards with both hands
until they engage with an audible click. In this middle po-
sition, they prevent the patient falling out of bed. When
raised at the head end, they also provide stable standing
and mobility assistance for the patient. (Fig. B, 1. – Pos. 3)
2. For telescopic movement, the side rail extension can be re-
leased using the two spring catches below the handrail and
adjusted to the position of extended fall prevention or their
maximum height. Pull the rail upwards using both hands si-
multaneously (Fig. A, 1. / 2). Take care not to tilt and jam the
element. Follow these actions in reverse to lower the rail.
Do not force the movement!
3. To lower the side rails, push the two release slides inwards
with both hands (Fig. B, 2.) and lower the side rails carefully
into the standby position.
Caution! When raising the side rails and side rail
height extensions, ensure and check that the latch-
es engage securely. Always use both hands to move
this element!
1.
1.
2.
2.
Fig. B
Fig. A
Pos. 2
Pos. 1