23
EN
Inserting the batteries
When inserting the batteries, make sure to observe the polarity. To do this,
look at the diagrams on the inside of the battery compartments.
TROUBLESHOOTING
Problem
Indicator
Possible solution
No sound.
The red transmitter LED
does not light up.
Switch on the transmitter. Make sure charged batteries
are installed correctly.
The transmitter LED lights
up.
Is the mute function activated?
The receiver LEDs light up.
Turn up the volume. Make sure that the connection from
the audio outputs to your mixing console or similar is
working.
The transmitter LEDs light
up, the receiver LEDs do
not light up.
Make sure that the frequencies on the transmitter and
receiver are set the same.
The signal strength is
significantly weaker than
with conventional cabling
/ Different guitars are at
different volumes.
The receiver LEDs light up.
Compensate for the problem using the GAIN control on
the transmitter and the volume control on the receiver.
Sound increasingly
distorted.
The receiver LEDs light up.
The batteries are dead. Change them.
Interferences are
disturbing the sound.
The signal LEDs light up.
Locate possible sources of interference (other
transmitters, steel reinforcements). Switch off
transmitters that are not needed. Mark "dead spots".
