Vinga
Wireless Door Chime with Flashing Light
READ THROUGH THE MANUAL CAREFULLY AND KEEP IT FOR
FUTURE REFERENCE
BATTERIES
You need 3xLR14 1,5V battery for the door chime (not included).
1x23A 12V battery for the bell press (included).
LOCATION
The distance between bell press and door chime can be approx.
40 metres, without any obstacles. Every door or wall will reduce
this distance. The condition of the battery can also reduce the
transmission range. Neither door chime nor bell press should be
placed over a radiator, on metal surfaces or close to electrical
equipment that might cause disturbance on the radio waves.
(Some doors and windows are aluminium armoured which might
reduce the transmission range.) The bell push should be mounted
on a wall or a door frame.
INSTALLATION OF DOOR CHIME
1. With the use of a screwdriver, remove the back of the door
chime.
2. To encode the door chime set, position the switches for ON
or OFF inside the door chime. The chosen combination has
to be exactly the same as the combination you will put in the
bell push. If the codes do not match, the communication
between the door chime and bell push will not work. If there
is a problem, just change the code combination.
3. Insert 3 new LR14-batteries, 1,5V. Check that they are inser-
ted correctly. Put the back of the door chime back.
4. The door chime can now be mounted on a wall using the rear
hang hole or it can be placed on a fl at surface.
INSTALLATION OF BELL PRESS
1. With the use of a screwdriver, remove the back of the bell
press.
2. Position the switches 1-6 for ON or OFF inside the bell press,
exactly the same way as you encoded the door chime.
3. Change the chime (”Ding dong” and ”Westminster”) by
changing the switches 7-8.
4. Insert the included 12V battery.
5. Mount the back of the bell press on the wall with the two
screws and screw plugs that are included.
6. Attach the bell press on the mounted back.
TROUBLESHOOTING
Problem -
The door chime does not sound.
Cause Remedy
The batteries are not
Make sure that the batteries
inserted correctly.
are inserted correctly.
The batteries are low.
Replace the batteries.
Encoding not done
Make sure that the six switches
correctly.
have the same combinations on
both
units.
The distance between the
Move the door chime closer to the
door chime and the bell
bell press.
press is too large.
The door bell is too close to
Move away the door chime from
other radio equipment.
electrical and metal equipment.
Door chime/bell press
If you have bought this set to com-
might not work with an old plement an old door chime, they
equipment.
might not be compatible.
Problem -
The door chime sounds when your bell press has not
been pressed.
Cause Remedy
A neighbour has used the
Change the code combination on
same code combination
both units.
as you.
SPECIFICATIONS
Door chime
Supply voltage: 3xLR14, 1,5V batteries (not included)/trafo 9V.
Codes: 36
combinations.
Bell press
Supply voltage: 1x12V (23A) battery (included).
Manual
53 383 71
Malmbergs Elektriska AB
Box 144, 692 23 Kumla, SWEDEN
Telefon: +46 (0)19 - 58 77 00 Fax: +46 (0)19 - 57 11 77
[email protected] www. malmbergs.com
