Malmbergs Elektriska AB, PO Box 144, SE-692 23 Kumla, SWEDEN
Phone: +46 (0)19 58 77 00 Fax: +46 (0)19 57 11 77 [email protected] www.malmbergs.com
OPErATION INSTrUCTIONS
1. Before programming for the first time, the battery has to be charged or connected to the mains.
Press ”rESET” to start the programming.
2. The timer is set to 24 hr mode. If you would like to change to 12 hr mode, press ”
” for 5 seconds
and the LCD will display "AM". If you would like to change it back to 24 hr mode, press "
” again
for 5 seconds.
3. Programming:
Step Key
Programming
1
Press ”P”
Set the first ON time (the display shows ”1 on”).
2*
Press ”D+”
Select the week day/period (if you would like to have the same time every day you
do not need to press this key).
3
Press ”H+/M+”
Set hours and minutes.
4
Press ”P”
Set the first OFF time (the display shows ”1 off”).
5
Press ”D+”
Select the week day/period (if you would like to have the same time every day you
do not need to press this key).
6
Press ”H+/M+”
Set hours and minutes.
7
repeat step 2-6
To set the rest of the ON/OFF times. Up to 8 ON/OFF.
8** Press ” ”
To end the programming.
To cancel, press ”MANUAL” and ”--:--” is shown on the display, to confirm the cancellation.
To resume with the initial setting, press ”MANUAL” again.
* 10 different modes: (1.MO 2.TU 3.WE 4.TH 5.Fr 6.SA 7.SU 8.MO, TU, WE, TH, Fr. 9.SA, SU.
10.MO, TU, WE, TH, Fr, SA, SU.)
** If you do not need 8 different time settings, press ”
” to end.
4. CLOCK SETTINg
(1) Press ”
” and ”D+” together until the correct date is shown.
(2) Press ”
” and ”H+” together until the correct hour is shown.
(3) Press ”
” and ”M+” together until the correct minute is shown.
(4) Press ”MANUAL” key to display ”ON AUTO” or ”OFF AUTO” (If this clock is in your programme is
ON selects ON AUTO, and this clock in your programme is OFF selects AUTO OFF).
5. If you would like to control the timer manually, press the ”MANUAL” key for ON or OFF (see the display).
NOTE! THE POWER CONSUMPTION OF CONNECTED ELECTRICAL APPLIANCES SHALL BE WITHIN THE
LIMITATION OF THE RATED CAPACITY (SEE TECHNICAL DATA ABOVE).
