TJ-JZ/JA-130308
MoUnTing
1. Mount the bracket on the wall.
2. insert the cable through the hole in the bracket and adjust the
length of the cable to suit the junction box and terminal block. See
pic 1. to see how to wire. it is not allowed to strip off the outer
cable between the junction box and the seal in body of the fitting.
3.
Note! It is very important that the four screws provided, are fixed
to the lamp holder (see pic. 4), the arrows indicate where. These
screws will stabilize the lamp holder to the reflector and body of
the fitting.
4. Mount the body on the bracket and connect the cable to the body.
5. insert an energy saving lamp, wattage and socket, see the table
above. incandescent lamp is not suitable in this fitting.
noTE
1. The supply lead must not be removed.
2. The fitting must not be covered.
3. The rating label with max power must not be removed from the
lamp.
TECHniCAL DATA
Lamp:
Energy saving lamp (wattage and socket, see the
table above).
Connection:
To terminal block 3x2.5 mm² through cable gland
M20.
Description:
Body and diffuser made of polycarbonate.
reflector made of anodised aluminium.
Hole dimension:
See picture 3.
Light sensor:
on approx. <20Lux, oFF approx. >20Lux
(art.no 77 170 23 and 77 170 25).
Protection class:
iP54.
* The installation cable must not be stripped off the outer cable and must be double insu-
lated (untouched) between the terminal block in the fitting and the junction box.
Cable: min 3x1.5 mm². Connection to terminal block: 3x2.5 mm².
Pic. 1*
L
H
Pic. 2
Pic. 3
50 mm
50 mm
Art.no
Max
W
Socket Weight
(kg)
Dimensions
LxWxH
(see pic. 2)
Twilight
switch
Certificate
77 170 03 1x23
E27
3.5
490x170x340 mm Without
CE+S
77 170 24 2x23
E27
3.7
490x170x340 mm Without
CE+S
77 170 23 1x23
E27
3.5
490x170x340 mm
With
CE
77 170 25 2x23
E27
3.7
490x170x340 mm
With
CE
Pic. 4
x4
Street Lamp Cupid
77 170 03, 23-25
inSTrUCTion MAnUAL
EN
Malmbergs Elektriska AB, Po Box 144, SE-692 23 Kumla, SWEDEn
Phone: +46 (0)19 58 77 00 Fax: +46 (0)19 57 11 77 [email protected] www.malmbergs.com
