9
EN
SAFETY PRECAUTIONS
Read carefully before use:
•
These instructions must be stored near the pump.
•
The instructions must always accompany the appliance in the event of ownership
transfer.
•
Only use the pump when submerged.
•
The pump may only be used if the housing and cable/plug are undamaged.
•
RCD should always be used for personal protection.
•
Children or people unfamiliar with these instructions may not use the pump.
•
Never change or alter the pump.
•
Never use the supply cable for lifting, transporting or fixing the device.
•
If the pump is damaged, do not use and send immediately to repair.
•
Check that any extension cords connected to the pump are undamaged.
•
Protect supply cable and extension cords from sharp edges, heat, moving parts, etc.
•
The pump is intended for temporary use only.
•
The pump shall be continuously monitored during operation.
•
The outlet from which the pump is powered from shall be protected with a residual
current device with a max. tripping current of 30mA.
APPLICATIONS
Suitable for pumping chemically neutral, slightly contaminated waste water with up to
2 mm grain size.
The pump is not intended for:
•
Corrosive, flammable and explosive media
•
Dirty water from urinal and lavatories
•
Water mixed with sand
OPERATION
•
Connect suitable hose (not supplied) to the pump using the hose clamp. Do not tight-
en too hard as this might damage the outlet hose.
•
Submerse the pump into the water using a rope. Tilt the pump when it is submersed
so that no air remains inside. Never pull or submerse the pump by holding the supply
cable or the outlet hose!
•
Make sure that the inlet is not blocked and that the unit stands on a level and stable
surface. The pump must not dig down into the ground, since it will get damaged.
•
Check if the voltage indicated on the type plate corresponds to the local mains volt-
age, then connect the appliance. Always protect sockets from water.
•
Monitor the pump continuously during operation.
