9
2. Touch control with LED display
1.
Press the “Power” button, the button control the “on” & “off ” of the hood.
2.
Keep pressing the button “Speed”, the motor runs as low / mid / high / low / mid…,
the speed runs circularly; and the LED display will indicate as 1-2-3-1-
2… circularly.
3.
Press “Light” button, the light is on, press this button again, the light is off, keep
pressing this button, the lights are on/off circularly.
Please note the Lamp is not under
control of the on/off button.
4. When the hood is work
ing, if press the “Timer” button, the hood will go into the
status of acquiescent working (acquiescent time is 9mins), and then, the LED display
will indicate as “9-8-7…-1-0”, when indicate “0”, the hood will be off automatically and
the lamp will extingui
sh. If keep pressing “Timer” button, the hood will go in or go out
“Timer” function.
TROUBLESHOOTING
Fault
Possible Cause
Solution
Light on, but motor
does not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact service center.
Motor failed
Contact service center.
Light does not
work, motor does
not work
House fuses blown
Reset/Replace fuses.
Power cord loose or
disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
One way valve and the outlet
are not tightly sealed
Take down the one way valve
and seal with sealant.
Leakage from the connection of
chimney and cover
Take chimney down and seal.
Lights not working
Broken/Faulty globes
Replace globes as per this
instruction.
Insufficient suction
The distance between the
cooker hood and the gas top is
too far
Refit the cooker hood to the
correct distance.
The Cooker hood
inclines
The fixing screw not tight
enough
Tighten the hanging screw and
make it horizontal.
NOTE:
Any electrical repairs to this appliance must conform to your local, state and
federal laws.Please contact the service centre if in any doubt before
undertaking any of the above.Always disconnect the unit from the power source when
