Tighten the nut anticlockwise by
wrench
Screw the nut anticlockwise
by hand
Remove the bottom cover and
disassemble the case of the sensor
by wrench
Or disassemble the case of the
sensor by the bottom cover if
the wrench is lost
Remove the old battery and
install a newone (positive pole
upward),then reinstall the
sensor according to the Inta-
above
Procedures of Installation
安装步骤
Screw the nuts to the bottom
of the valve core
A、拧入防盗六角螺母
Screw the sensors tightly
B、拧紧传感器
C、用手将防盗六角螺母逆时针方
向拧紧,顶着传感器底部
D、用扳手逆时针拧紧防盗六角螺母
Battery Replacement
更换电池
Screw the nu t clockwise to separate
it from the sensor by wrench and
then screw out the
by hand
sensor
A、用扳手顺时针方向旋转六角螺母，
将其与传感器分离，再逆时针方
向旋转传感器
B、取下防拆底盖，用扳手扣紧传
感器，并逆时针旋转以拆开传
感器外壳
C、若扳手丢失或损坏，可将防拆
底盖取下并方向扣紧传感器，
逆时针旋转拆开传感器
D、取出旧电池并装上新电池（正
极朝上），最后按照安装步骤
重新将传感器安装好
llation steps
