Driver’s Seat
The driver’s seat can be adjusted forward and backward by
pulling the lever located on front left side of the drivers
seat. Pull lever outward and adjust seat as needed.
Lumbar Support
The driver’s seat is equipped with a Lumbar Support. To
adjust, locate the twist knob located on the left side of the
seat bottom. Turn the knob clockwise to increase lean back
tension, or counterclockwise to decrease tension.
Swivel Seat Base
Some models are also equipped with a swivel seat
adjustment. To adjust the seat, release the lever directly
below the front center of the drivers seat area by lowering
to the bottom of the seat base. Locate the twist knob on
the left center of the seat base, (this knob is different than
the Lumbar Support) and turn counterclockwise to loosen.
The seat should swivel freely. To reset the seat position,
simply reverse these steps.
Integral Self Draining Ice Chest
This item is available on most model boats and can be found either in the observer seat
base, center floor or under bow cushion seating areas. The melted water will drain into
the bilge area of your boat.
2-15
Figure 2-13. Bolster Seat
Figure 2-14. Lumbar Adjuster
Figure 2-15. Seat Adjuster
Chapter 2 doc.qxd: Chapter 2 doc.qxd 1/11/07 5:39 AM Page 15
Summary of Contents for Response lx
