adjust the angle of the solar panel, but it is stiff enough to remain in
the set position.
d)
Mark the places of the fixing holes of the U-profile bracket with the
solar panel on the chosen surface.
e)
Drill the 2 holes.
f)
Push the 2 screws together with the hit-
in dowels on them inside the holes with
a hammer.
g)
Remove the nuts and the upper washers
from the screws (leave the lower washers
on them)
h)
Place the U-profile bracket with the solar
panel on its final position on the screws.
i)
Place the washers then the nuts on the
screws, drive the nuts by hand until you can, then tighten them with
a wrench.
Fixing the flood light:
a)
It is recommended to position the light on its final place, then mark
the 2 locations of the holes. The holes located on the lower part of the
light’s U-profile are the fixing points.
b)
After marking the locations of the holes, remove the light, and drill
the holes.
c)
Push 2 screws together with the hit-in dowels on them inside the holes
with a hammer.
d)
Remove the nuts and the upper washers from the screws (leave the
lower washers on them)
USER INSTRUCTIONS
USER INSTRUCTIONS
e)
Place the light on its final position on the screws.
f)
Place the washers then the nuts on the screws, drive the nuts by hand
until you can, then tighten them with a wrench.
g)
The vertical angle of the flood light is adjustable. If you would like to
loosen or tighten the adjustment of the angle, please use an allen key
to tighten or loosen the 2 screws located at the connection points of
the U-profile bracket, and the light body. The allen key is not the part
of the package.
h)
The solar panel is supplied with 3 m cable. Please make sure to set up
the distance between the flood light, and the solar panel correctly not
to exceed the cable length. The plug of the solar panel’s cable should
be correctly attachable to the light cable’s plug. Please make sure you
plug the 2 cables correctly together, then roll on the threaded plastic
cap on the connection point, and tighten it gently by hand (CARE! Do
not overtighten!).
Operating & customizing the light, functions of the remote control:
By attaching the solar panel cable’s plug to the flood light cable’s plug,
the light automatically turns ON. Whenever sufficient light is provided,
the solar panel starts to charge the battery. The light will be operated by
the light sensor onwards, the default setup is automatic (AUTO). You can
customize the operation of the light by the remote control.
Functions of the remote control:
Turn the light OFF (the light
will not turn on at dusk on the
next day)
Automatic mode,
ON and OFF automatically by
the light sensor
Time control: 3-hour operation
after being turned on by the
light sensor
Time control: 5-hour operation
after being turned on by the
light sensor
Time control: 8-hour operation
after being turned on by the
light sensor
Decrease power
Increase power
Maximum power
Turn OFF the current workflow.
You can turn OFF the light with
this button, but it will turn on
again on the next day at dusk.
6
7
