Date of publication 15th October 2014
www.malacrino.co.uk
- 4 -
1. Remove protective wrapping and slide the left hand decorative trim under the retaining clips
on the left side on the fire taking care not to scratch the face ( Step A )
2. Remove protective wrapping and slide the right hand decorative under the retaining clips on
the right side of the fire taking care not to scratch the face of the fire ( Step B )
3. Remove protective wrapping and slide the top decorative trim over the left and right hand
decorative trims and into the retaining clips ( Step C
)
4. Using the self tapping screws provided attach the decorative trim to the appliance main outer
frame at the rear of the fire through the pre drilled holes, be careful not to over tighten the
screws
Step A Step B Step C
5. Insert the type X male attachment mains lead into the base of the fire where the X attachment
female slot is located, once located, use the cable ties provided to secure the lead in either left
or right position as per installation requirement
6. Slide the fire into its desired fixing location, feeding the power cable towards the power source
at the same time
7. Tighten the 4 by 30 screws supplied until the fire fits snuggly over the screw heads
8. Slide the decorative fret onto the four locating screws at the bottom of the fire ( step D to F )
Step D Step E Step F
9. Connect the appliance to the power supply using the desired method of connection
