Maktec MT230, Instruction Manual

Page: 7 / 16

7
1
007832
With the tool unplugged, rotate the blade by hand while
holding the handle all the way down to be sure that the
blade does not contact any part of the lower base.
Re-adjust slightly, if necessary.
2
1
3
130mm
007831
CAUTION:
•
After installing a new blade, always be sure that the
blade does not contact any part of the lower base
when the handle is lowered completely. Always do
this with the tool unplugged.
Adjusting the miter angle
1
2
007768
Loosen the grip by turning counterclockwise. Turn the
turn base while pressing down the lock lever. When you
have moved the grip to the position where the pointer
points to the desired angle on the miter scale, securely
tighten the grip clockwise.
CAUTION:
•
When turning the turn base, be sure to raise the
handle fully.
•
After changing the miter angle, always secure the
turn base by tightening the grip firmly.
Adjusting the bevel angle
1
007763
1
007757
To adjust the bevel angle, loosen the knob at the rear of
the tool counterclockwise.
Push the handle to the left to tilt the saw blade until the
pointer points to the desired angle on the bevel scale.
Then tighten the knob clockwise firmly to secure the
arm.
CAUTION:
•
When tilting the saw blade, be sure to raise the
handle fully.
•
After changing the bevel angle, always secure the
arm by tightening the knob clockwise.
Switch action
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
For European countries
1
2
007900
To start the tool, push the lever to the right and then pull
the switch trigger. Release the switch trigger to stop.
1. Lever
2. Switch trigger
1. Pointer
1. Knob
1. Lock lever
2. Grip
1. Top surface of
turn base
2. Periphery of
blade
3. Guide fence
1. Adjusting bolt