Maktec M9400 Instruction Manual Download Page 6

When the dust bag is about half full, remove the dust 
bag from the tool and pull the fastener out. Empty the 
dust bag of its contents, tapping it lightly so as to 
remove particles adhering to the insides which might 
hamper further collection. 

OPERATION 

Sanding operation 

   

013118 

CAUTION: 

• 

The tool should not be in contact with the 
workpiece surface when you turn the tool on or off. 
Otherwise a poor sanding finish or damage of the 
belt may result. 

Hold the tool firmly with both hands. Turn the tool on 
and wait until it attains full speed. Then gently place the 
tool on the workpiece surface. Keep the belt flush with 
the workpiece at all times and move the tool back and 
forth. 
Never force the tool. The weight of the tool applies 
adequate pressure. Excessive pressure may cause 
stalling, overheating of the motor, burning of the 
workpiece and possible kickback. 

MAINTENANCE 

 

CAUTION: 

• 

Always be sure that the tool is switched off and 
unplugged before attempting to perform inspection 
or maintenance. 

• 

Never use gasoline, benzine, thinner, alcohol or 
the like. Discoloration, deformation or cracks may 
result. 

Replacing carbon plate 

1

2

3

 

 

013119 

 

Replace an carbon plate on the cork rubber plate when 
it is worn down. Remove screws on the strap washer 
and the worn carbon plate, place a new carbon plate 
and then secure it with the screws. 

Replacing carbon brushes 

1

 

 

001145 

Remove and check the carbon brushes regularly. 
Replace them when they are worn down to the limit 
mark. Keep the carbon brushes clean and free to slip in 
the holders. Both carbon brushes should be replaced at 
the same time. Use only identical carbon brushes. 
Use a screwdriver to remove the brush holder caps. 
Take out the worn carbon brushes, insert the new ones 
and secure the brush holder caps. 

1

2

 

 

013120 

To maintain product SAFETY and RELIABILITY, repairs, 
any other maintenance or adjustment should be 
performed by Makita Authorized Service Centers, 
always using Makita replacement parts. 

1. Brush holder 

cap 

2. Screwdriver 

1. Limit mark 

1. Strap washer 
2. Cork rubber 

plate 

3. Carbon plate 

Reviews: