8 ENGLISH
Changing the impact force
4
1
2
3
5
►
1.
Hard
2.
Soft
3.
Reverse rotation auto stop mode
4.
Changed in three steps
5.
Button
You can change the impact force in three steps: hard,
soft, and Reverse rotation auto stop mode.
This allows a tightening suitable to the work.
Every time the button is pressed, the number of blows
changes in three steps.
The function of Reverse rotation auto stop mode works only with pulling the trigger fully in counterclockwise tool
rotation. When the bolt/nut gets enough loosened, the tool stops the impact and rotation.
For approximately one minute after releasing the switch trigger, the impact force can be changed.
Impact force grade displayed
on panel
Maximum blows
Purpose
Example of application
Hard
3,600 min
-1
(/min)
Tightening when force and
speed are desired.
Assembling steel frames.
Soft
2,000 min
-1
(/min)
Tightening when you need fine
adjustment with small diameter
bolt.
Assembling furnitures.
Reverse rotation auto stop
mode
3,600 min
-1
(/min)
Loosening with auto stop
function.
Disassembling bolts/nuts.
NOTE:
Reverse rotation auto stop mode is available only when the tool rotates counterclockwise. When rotating
clockwise in Reverse rotation auto stop mode, the impact force and speed are the same as Hard impact mode.
NOTE:
When all lamps on the switch panel go out, the tool is turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
NOTE:
While pulling the switch trigger, the impact force grade cannot be changed.
