7
014858
When cutting straight line, clamp a straight board firmly
to the material and use it as a guide. Move the tool in
the direction of the arrow with the shoe base flush with
the side of the guide board.
When the cut is complete, turn the tool off and wait for
the bit to stop rotating and then carefully remove it from
the material.
NOTE:
•
When using this tool, the rotating action causes
the tool to pull. The less pressure applied to the
tool causes less pull and provides a more accurate
cut. Excessive pressure or fast cutting can cause
the bit to dull or break premature.
•
When cutting drywall around outlet boxes, cut in a
counterclockwise direction for ease of cut.
•
The standard bit included with this tool is for
cutting drywall only. When cutting materials other
than drywall, do not use the standard drywall
guide bit.
Using multipurpose bit (optional accessory)
014870
When using the multipurpose bit into the material, hold
the tool at approximately a 45 degree angle with the
edge of the shoe base contacting the material.
014871
Bring the tool carefully to a straight position so the shoe
base contacts the material fully.
Circular guide (optional accessory)
Circular cutting diameters: 10 cm (4") - 34 cm (13-3/8")
Installing circular guide
1
2
014865
Release the thumb screw which secures the shoe.
1
2
014866
Align the projections in the circular guide with the
grooves in the shoe, and secure the shoe and circular
guide with the thumb screw.
1
2
3
4
5
014867
To adjust the cutting depth, loose the thumb screw and
then slide the shoe with the circular guide. After the
proper adjustment, tighten the thumb screw securely.
Using circular guide
1
2
3
014863
Loosen the knob, and adjust its position in accordance
with the size of the circle to be cut. (The hole
dimensions to be cut are indicated on the side of the
circular guide as a general guideline.) After completion
1. Knob
2. Tighten
3. Loosen
1. Thumb screw
2. Circular guide
3. Shoe
4. Loosen
5. Tighten
1. Projections
2. Shoe
1. Thumb screw
2. Shoe
Summary of Contents for XSF03
Page 67: ...11 ...