7
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing application tool
(optional accessory)
WARNING:
•
Do not install application tool upside down.
Installing application tool upside down may
damage the tool and cause serious personal injury.
•
Install attachment tool in the correct direction
according to your work. Application tool can be
installed at an angle of every 30 degree.
CAUTION:
•
Be careful when closing the lock lever. The lock
lever may close suddenly and pinch your finger.
•
Clean up dust and perform lubrication on the
moving part of the lock lever from time to time.
Otherwise dust may accumulate in the moving part
of the lock lever and hinder its smooth movement.
•
Do not start the tool while the lever opens. The
tool may be damaged.
1.
Open the lock lever fully. And remove the holder
bolt.
1
2
014555
2.
Put an application tool (optional accessory) on
the tool flange so that the protrusions of the tool
flange fit in the holes in the application tool.
2
2
1
1
3
014553
3.
Insert the holder bolt till it stops. And then, return
the lock lever to its original position.
014564
When using sanding application tool, mount the
application tool on the sanding pad so that it matches
the sanding pad direction.
The sanding pad has a hook and loop type fitting
system which allows easy and rapid fitting of a sanding
paper.
As sanding papers have holes for dust extraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
To remove the holder bolt, follow the installation
procedures in reverse.
1
014554
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
OPERATION
WARNING:
•
Before starting the tool and during operation, keep
your hand and face away from the application tool.
CAUTION:
•
Do not apply excessive load to the tool which may
cause a motor lock and stop the tool.
Cutting, sawing and scraping
CAUTION:
•
Do not move on the tool forcibly in the direction
(eg. towards either side) of tool application with no
cutting edge. It may damage the tool.
1. Adapter
1. Holder bolt
2. Holes in the
application tool
3. Protrusions of
the tool flange
1. Holder bolt
2. Lock lever
