15 ENGLISH
Wet cutting with water supply hose
CAUTION:
Always pay attention to the control
of water pressure. Too high water pressure may
cause water leak and splashing.
1.
Set the water supply lever in the “ON” (I) position.
3
2
1
►
1.
Water supply lever
2.
“ON” (I) position
3.
“OFF”
(O) position
2.
Start feeding water to the diamond wheel by
turning the mains water supply on. Water flow can be
adjusted by moving the water supply lever. Turn the
lever to the “ON” (I) position to increase flow, and to the
“OFF” (O) position to reduce flow.
3.
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the diamond wheel making any contact.
Straight cutting
45° bevel cutting
4.
Turn the tool on and wait until the diamond wheel
attains full speed. Then move the tool forward over
the workpiece surface, keeping it flat and advancing
smoothly until the cutting is completed. Keep your
cutting line straight and your speed of advance uniform.
5.
Having finished operation, be sure to set the lever
in the “OFF” (O) position to cut flow off and turn the
water off.
WIRELESS ACTIVATION
FUNCTION
Optional accessory
NOTICE:
Install the optional dust cover and
accessories before using this function.
What you can do with the wireless
activation function
The wireless activation function enables clean and com-
fortable operation. By connecting a supported vacuum
cleaner to the tool, you can run the vacuum cleaner
automatically along with the switch operation of the tool.
To use the wireless activation function, prepare follow-
ing items:
•
A wireless unit (optional accessory)
•
A vacuum cleaner which supports the wireless
activation function
Summary of Contents for XCC01
Page 47: ...47 ...
