1.
Before using battery cartridge, read all instructions and
cautionary markings on (1) battery charger, (2) battery,
and (3) product using battery.
2.
Do not disassemble battery cartridge.
3.
If operating time has become excessively shorter, stop
operating immediately. It may result in a risk of
overheating, possible burns and even an explosion.
4.
If electrolyte gets into your eyes, rinse them out with clear
water and seek medical attention right away. It may result
in loss of your eyesight.
5.
Do not short the battery cartridge:
(1) Do not touch the terminals with any conductive
material.
(2) Avoid storing battery cartridge in a container with
other metal objects such as nails, coins, etc.
(3) Do not expose battery cartridge to water or rain.
A battery short can cause a large current flow,
overheating, possible burns and even a breakdown.
6.
Do not store the tool and battery cartridge in
locations
where the temperature may reach or exceed
122 °F.
7.
Do not incinerate the battery cartridge even if it is
severely damaged or is completely worn out. The
battery cartridge can explode in a fire.
8.
Be careful not to drop or strike battery.
9.
Do not use a damaged battery.
10.
The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements.
For
commercial transports e.g. by third parties, forwarding
agents, special requirement on packaging and labeling
must be observed.
For preparation of the item being shipped, consulting
an
expert for hazardous material is required. Please also
observe possibly more detailed national regulations.
Tape
or mask off open contacts and pack up the battery in
such
a manner that it cannot move around in the
packaging.
11.
When disposing the battery cartridge, remove it from
the tool and dispose of it in a safe place. Follow your
local regulations relating to disposal of battery.
12.
Use the batteries only with the products specified by
Makita.
Installing the batteries to non-compliant
products may result in a fire, excessive heat, explosion,
or
leak of electrolyte.
13.
If the tool is not used for a long period of time, the
battery must be removed from the tool.
SAVE THESE INSTRUCTIONS.
Tips for maintaining maximum battery life
1.
Charge the battery cartridge before completely dis-
charged. Always stop tool operation and charge the
battery cartridge when you notice less tool power.
2.
Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
3.
Charge the battery cartridge with room tempera-
ture at 50 °F - 104 °F. Let a hot battery cartridge
cool down before charging it.
4.
Charge the battery cartridge if you do not use it
for a long period (more than six months).
ASSEMBLY
Installing suction pipe and nozzle
1.
Align the triangle mark on the suction nozzle
with that on the suction pipe, and then insert the
suction nozzle into the suction pipe until the latch on
the nozzle snaps into place.
►
1.
Suction nozzle
2.
Suction pipe
3.
Triangle mark
2.
Loosen the bolt on the fan cover using the
hex wrench, and open the fan cover.
1
2
3
3
NOTICE:
Before operating the machine, be sure
to completely assemble the machine.
Otherwise,
the machine does not work.
CAUTION:
Always be sure that the machine is
switched off and the battery cartridge is
removed before carrying out any work on the
machine.
Important safety instructions for
battery cartridge
1
2
3
►
1.
Bolt
2.
Fan cover
3.
Hex wrench
CAUTION:
Only use genuine Makita batteries.
Use
of non-genuine Makita batteries, or batteries that have
been altered, may result in the battery bursting causing
fires, personal injury and damage. It will
also void the
Makita warranty for the Makita tool and charger.