19
ENGLISH
2.
Adjust the hanger position as shown in the figure
and then tighten the hex socket bolt.
1
2
3
750 mm
750 mm
100-300 mm
►
1.
The hanger position from the ground
2.
The
cutting tool position from the ground
3.
The horizon-
tal distance between the hanger and the unguarded
part of the cutting tool
Correct handling of the tool
WARNING:
Always position the tool on your
right-hand side.
Correct positioning of the tool allows
for maximum control and will reduce the risk of seri-
ous personal injury caused by kickback.
WARNING:
Be extremely careful to maintain
control of the tool at all times. Do not allow the
tool to be deflected toward you or anyone in the
work vicinity.
Failure to keep control of the tool
could result in serious injury to the bystander and the
operator.
WARNING:
To avoid accident, leave more
than 15m (50 ft) distance between operators when
two or more operators work in one area. Also,
arrange a person to observe the distance between
operators. If someone or an animal enter the
working area, immediately stop the operation.
CAUTION:
If the cutting tool accidentally
impacts a rock or hard object during operation,
stop the tool and inspect for any damage. If the
cutting tool is damaged, replace it immediately.
Use of a damaged cutting tool may result in serious
personal injury.
CAUTION:
Remove the blade cover from the
cutter blade when cutting the grass.
Correct positioning and handling allow optimum control
and reduce the risk of injury caused by kickback. The
way of cutting varies depending on the cutting tool to
be used.
2-tooth, 3-tooth, 4-tooth, 8-tooth
blades, nylon cutting head, and
plastic blade
These cutting tools are useful for cutting grass and
weeds. Swing the tool evenly in a half-circle from right
to left. Repeat right-to-left stroke while advancing
forward.
When using a nylon cutting head (bump & feed
type)
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed out the nylon cord, tap the cutting head against
the ground while rotating.
1
►
1.
Most effective cutting area
NOTICE:
The bump feed will not operate prop-
erly if the nylon cutting head is not rotating.
NOTE:
If the nylon cord does not feed out while
tapping the head, rewind/replace the nylon cord
by following the procedures in the section for the
maintenance.
Summary of Contents for UR012GT201
Page 22: ...22 ENGLISH B F Z5L 1 2 3 5 4 6 7 8 3 m 80 mm 100 mm ...
Page 23: ...23 ENGLISH 121 M10L 1 2 4 3 5 6 3 m 100 mm ...
Page 26: ...26 ...
Page 27: ...27 ...
