8
1
2
009293
To remove the chip receiver, press its lever on both
sides so that the hooks are unlocked.
CAUTION:
•
The blade cover (standard equipment) cannot be
installed on the tool with the chip receiver being
installed. Before carrying or storing, uninstall the
chip receiver and then install the blade cover to
avoid blade exposure.
NOTE:
•
Check the chip receiver for secure installment
before use.
•
Never try to uninstall the chip receiver by an
excessive force with its hooks locked in the blade
unit grooves. Using the excessive force may
damage it.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
Cleaning the tool
Clean out the tool by wiping off dust with a dry or soap-
dipped rag.
CAUTION:
•
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
Blade maintenance
Smear the blade before and once per hour during
operation using machine oil or the like.
NOTE:
•
Before smearing the blade, remove the chip
receiver.
After operation, remove dust from both sides of the
blade with wired brush, wipe off it with a rag and then
apply enough low-viscosity oil, such as machine oil etc.
and spray-type lubricating oil.
CAUTION:
•
Do not wash the blades in water. Failure to do so
may cause rust or damage on the tool.
Removing or installing shear blade
CAUTION:
•
Before removing or installing shear blade, always
be sure that the tool is switched off and the battery
cartridge is removed.
•
When replacing the shear blade, always wear
gloves without removing blade cover so that hands
and face does not directly contact the blade.
Failure to do so may cause personal injury.
NOTE:
•
Do not wipe off grease from the gear and crank.
Failure to do so may cause damage to the tool.
Removing the shear blades
1
2
012447
Reverse the tool and loosen four screws and remove
the under cover.
NOTE:
•
Be careful not to get your hands dirty as grease is
applied in the shear blade driving area.
1
1
2
3
012451
Loosen four screws and remove the blades. Remove
the washer and sponge from the shear blades and put
them aside. They are required for the later installation.
1. Screws
2. Sponge
3. Washer
1. Screws
2. Under cover
1. Press the levers
on both sides
2. Unlock the
hooks
