12 ENGLISH
2.
Connect a vacuum cleaner to the dust nozzle.
Fig.28
How to use screw M6 x 135 for
adjusting the depth of cut
When using the tool with a router table available in the
market, using this screw allows an operator to obtain
a small amount of adjustment of the depth of cut from
above the table.
Installing the screw with washer on
the tool
Insert the screw with washer through a screw hole on
the tool base and then screw in the threaded part of
the motor bracket of the tool. At this time, apply some
grease or lubricating oil to the inside of the screw hole
on the tool base and the threaded part of the motor
bracket.
2
1
Fig.29
►
1.
Flat washer 6
2.
Screw M6 x 135
1
Fig.30
►
1.
Screw M6 x 135 in a screw hole
1
2
Fig.31
►
1.
Screw M6 x 135
2.
Threaded part of the motor
bracket
Adjusting the depth of cut
1.
A small amount of depth of cut can be obtained
by turning this screw with a screwdriver from above the
table. (1.0 mm per a full turn)
2.
Turning the screw clockwise makes the depth
of cut greater and turning the screw counterclockwise
makes the depth of cut smaller.
1
Fig.32
►
1.
Screwdriver
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
