8 ENGLISH
A
B
Fig.4
To prevent the switch trigger from accidentally pulled,
the trigger-lock button is provided.
To pull the switch trigger, depress the trigger-lock button
from A side.
After use, always press in the trigger-lock button from
B side.
Adjusting the depth of pin-nailing
WARNING:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before adjusting the depth of nailing.
Depth of pin-nailing can be adjusted by turning the
adjuster on the tool. A pin nail drives deeper as you turn
the adjuster in the A direction shown in the figure, and
shallower in the B direction, within a range of up to 1.5
mm.
1
A
B
Fig.5
►
1.
Adjuster
2
1
3
Fig.6
►
1.
Too deep
2.
Right depth
3.
Too shallow
Lighting up the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger or actuate the contact element
to light up the lamp. The lamp remains lit for up to 60
seconds while pulling the switch trigger or actuating
the contact element. The lamp goes out approximately
10 seconds after releasing the switch trigger and the
contact element.
1
Fig.7
►
1.
Lamp
NOTICE:
Use a dry cloth to wipe the dirt off the
lens of the lamp. Be careful not to scratch the lens
of lamp, or it may lower the illumination.
NOTICE:
The tool may not fire pin nails after the
battery becomes low on power even while the
lamp remains lit. In this case, charge the battery
cartridge.
NOTICE:
When the tool is overheated, the lamp
flashes. In this case, release the switch trigger
and contact element, and then cool down the tool/
battery before operating again.
NOTICE:
The lamp starts blinking if the pin nailer
detects an error during driving pin nails. In this
case, bring the pin nailer to a Factory Service
Center.
