6-15-2
Adjustment of valve clearance
Adjust the valve clearance as follows:
[1] Align each marking on Flywheel parallel to Crankcase. (
Fig. 6-15-1-2-3
)
6-15-3
Assembling of Muffler exhaust and Insulator complete
Fig. 6-15-3-1
Assemble Muffler exhaust and Insulator complete as shown below.
Fig. 6-15-2-1
[2] Loosen Adjusting screws, and insert 0.1mm feeler
gauge of 1R366 into the clearance between Rocker arms
and Intake/ exhaust valve holes.
Tighten and loosen Adjusting screws so that 0.1mm
feeler gauge can be passed and 0.15mm feeler gauge
cannot. (Recommended value: 0.1mm)
After adjustment, tighten M5 Hex nuts while slightly
holding Adjusting screws to the screwed direction, and
pull out the feeler gauge.
[3] Turn Flywheel a few times to check that the clearance is
appropriate.
Fig. 6-15-2-2
[4] Assemble Rocker cover gasket and Rocker cover
complete to Cylinder head complete with two M5x30
Hex socket head bolts.
0.1mm feeler gauge
of 1R366
Offset wrench 8
Hex wrench 2.5
Rocker cover
complete
Rocker cover
gasket
M5x30 Hex socket
head bolt (2 pcs.)
Cylinder head
complete
Rocker arm
Adjusting screw
M5 Hex nut
Muffler
exhaust
M6x18 Socket head
bolt (2 pcs.)
Note:
with adhesive
Muffler
gasket
Exhaust port
spacer
Insulator
complete
M5x25 Hex socket
head bolt (2 pcs.)
Note:
with adhesive
M5x14
Socket head
bolt
39 / 41
