R
epair
P 13 / 15
(10) Disassembling handle section
1. Unscrewing 4 pcs. of tapping screws M4x30 and 2 pcs. of tapping screws M4x20, remove handle R
from handle L. So, the inner parts (for instance switch, terminal, etc.) can be removed. See Fig. 21.
2. Remove bumper, carbon brush and brush holder cap from motor housing. Then, brush holder can be removed.
See Fig. 22.
Tapping screws M4x30
Tapping screws M4x30
Tapping screws M4x20
Handle R
Switch
Terminal
Lock off butt
Fig. 21
Bumper
Brush holder
Brush holder cap
Carbon brush
Brush holder cap
Carbon brush
Fig. 22
(11) Note in assembling handle section
Insert leaf spring for High-Low speed change lever into the groove of handle L and insert its another end into
the groove of handle R firmly. See Fig. 23.
After assembling, check whether speed change lever can be locked by leaf spring on "L" and "H" side
respectively, when speed change lever is slid.
Fig. 23
Leaf spring
Handle L
This side has to come into
the groove of handle R.
