5
19.
Make sure the shaft lock is released before the
switch is turned on.
20.
Be sure that the blade does not contact the
turn base in the lowest position.
21.
Hold the handle firmly. Be aware that the saw
moves up or down slightly during start-up and
stopping.
22.
Make sure the blade is not contacting the
workpiece before the switch is turned on.
23.
Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced blade.
24.
Wait until the blade attains full speed before
cutting.
25.
Stop operation immediately if you notice
anything abnormal.
26.
Do not attempt to lock the trigger in the "ON"
position.
27.
Be alert at all times, especially during
repetitive, monotonous operations. Do not be
lulled into a false sense of security. Blades are
extremely unforgiving.
28.
Always use accessories recommended in this
manual. Use of improper accessories such as
abrasive wheels may cause an injury.
29.
NEVER hold workpiece on right side of blade
with left hand or vice versa. This is called
cross-armed cutting and exposes user to risk
of SERIOUS PERSONAL INJURY as shown in
the figure. ALWAYS use vise to secure
workpiece.
000030
30.
Do not abuse cord. Never yank cord to
disconnect it from the receptacle. Keep cord
away from heat, oil, water and sharp objects.
31.
NEVER stack workpieces on the table top to
speed cutting operations. Cut only one piece
at a time.
32.
Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
USB088-1
ADDITIONAL SAFETY RULES
FOR THE LASER
CAUTION:
•
LASER RADIATION DO NOT STARE INTO
BEAM.
•
AVOID EXPOSURE - LASER RADIATION IS
EMITTED FROM APERTURE.
•
USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION
EXPOSURE.
Complies with 21CFR
1040.10 and 1040.11
AVOID EXPOSURE-Laser
radiation is emitted from
LASER RADIATION
this aperture
DO NOT STARE INTO BEAM
Maximum Output
<1mW,Wavelength:655nm
CLASS II LASER PRODUCT
CAUTION
000189
Summary of Contents for LS1214FL
Page 79: ...79 ...
