17 ENGLISH
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
press in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
A hole is provided in the switch trigger for insertion of a
padlock to lock the tool off.
WARNING:
Do not use a lock with a shank
or cable any smaller than 6.35 mm in diameter.
A
smaller shank or cable may not properly lock the tool
in the off position and unintentional operation may
occur resulting in serious personal injury.
Lighting up the lamp
CAUTION:
The lamp is not a rainproof . Do
not wash the lamp in water or use it in a rain or
a wet area.
Such a conduct can cause an electric
shock and fume.
CAUTION:
Do not touch the lens of the lamp
as it is very hot while it is lighted or shortly after it
is turned off.
This may cause burns.
CAUTION:
Do not apply impact to the lamp,
which may cause damage or shorted service time
to it.
CAUTION:
Do not keep casting the beam of
the light to your eyes.
This can cause your eyes to
be hurt.
CAUTION:
Do not cover the lamp with
clothes, carton, cardboard or similar objects
while it is lighted, which can cause a fire or an
ignition.
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the light, press the upper position (I) of the
lamp switch. To turn off the light, press the lower posi
-
tion (0) of the lamp switch.
2
1
►
1.
Lamp
2.
Lamp switch
NOTE:
Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE:
Be sure to turn off the lamp switch after use
because turning on the light consumes the battery
power.
Laser beam action
CAUTION:
Never look into the laser beam.
Direct laser beam may injure your eyes.
To turn on the laser beam, press the upper position (I)
of the switch. To turn off the laser beam, press the lower
position (0) of the switch.
1
►
1.
Laser switch
NOTE:
Be sure to turn off the switch as turning on the
switch consumes the battery power.
Laser line can be shifted to either the left or right side
of the circular saw blade by turning the adjusting screw
as follows.
1
►
1.
Adjusting screw
1.
Loosen the adjusting screw by turning it
counterclockwise.
2.
With the adjusting screw loosened, slide the
adjusting screw to the right or left as far as it goes.
3.
Tighten the adjusting screw firmly at the position
where it stops sliding.
NOTE:
Laser line is factory adjusted so that it is
positioned within 1 mm from the side surface of the
circular saw blade (cutting position).
NOTE:
When laser line appears dim and hard to see
because of direct sunlight, relocate the work area to a
place where there is less direct sunlight.
Summary of Contents for LS001G
Page 39: ...39 ...
