12
NOTE:
•
To change the rip fence pattern, remove the rip
fence from the rip fence holder by loosening the
clamping screw (A) and change the facing of the rip
fence to the rip fence holder so that the rip fence
faces the rip fence holder according to your work as
shown in the figure.
Insert the square nut on the rip fence holder into the
back end of either slit of the rip fence so that they fit
as shown in the figure.
To change from the pattern A or B to the pattern C
or D, or in adverse case, remove the square nut,
washer and clamping screw (A) from the rip fence
holder, then position the clamping screw (A),
washer and square nut on the opposite position of
the rip fence holder compared to the original
position Tighten the clamping screw (A) securely
after inserting the square nut of the rip fence holder
into the rip fence slit.
Insert the square nut on the rip fence holder into the
back end of either slit of the rip fence so that they fit
as shown in the figure.
1
3
2
4
5
6
005552
The rip fence is factory adjusted so that it is parallel to the
blade surface. Make sure that it is parallel. To check to be
sure that the rip fence is parallel with the blade. Lower
the table to the lowest position so that the blade appears
at the topmost position from the table. Mark one of the
blade teeth with a crayon. Measure the distance (A) and
(B) between the rip fence and blade. Take both
measurements using the tooth marked with the crayon.
These two measurements should be identical If the rip
fence is not parallel with the blade, proceed as follows:
1
1
005556
(1) Turn two adjusting screws counterclockwise.
1
2
3
3
005557
3
2
1
005558
(2) Shift the back edge of the rip fence slightly to right
or left until it becomes parallel with the blade.
(3) Tighten the two screws on the rip fence firmly.
CAUTION:
•
Be sure to adjust the rip fence so that it is parallel with the
blade, or a dangerous kickback condition may occur.
•
Be sure to adjust the rip fence so that it does not
contact the top blade guard or saw blade.
Dust bag
1
1
4
2
3
005559
The use of the dust bag makes cutting operations clean
and dust collection easy. To attach the dust bag, fit it onto
the dust nozzle.
NOTE:
•
In miter saw mode, always insert the dust bag to
the back nozzle only.
When the dust bag is about half full, remove the dust bag
from the tool and pull the fastener out. Empty the dust
bag of its contents, tapping it lightly so as to remove
particles adhering to the insides which might hamper
further collection.
1. Dust nozzle
2. Dust bag
3. Fastener
4. Cap
1. Rip fence
2. Saw blade
3. Top blade guard
1. Rip fence
2. Rip fence holder
3. Two screws
1. Scale
1. Rip fence
2. Rip fence holder
3. Square nut
4. Clamping screw
(A)
5. Clamping screw
(B)
6. Washer
