Makita HP333D, Instruction Manual

Page: 5 / 80

5 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model: HP333D
Drilling capacities Masonry 8 mm
Steel 10 mm
Wood 21 mm
Fastening capacities Wood screw 5.1 mm x 63 mm
Machine screw M6
No load speed High (2) 0 - 1,700 min
-1
Low (1) 0 - 450 min
-1
Blows per minute High (2) 0 - 25,500 min
-1
Low (1) 0 - 6,750 min
-1
Overall length 193 mm
Rated voltage D.C. 10.8 V - 12 V max
Net weight 1.1 - 1.3 kg
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi
-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
BL1015 / BL1016 / BL1020B / BL1021B / BL1040B / BL1041B
Charger
DC10SA / DC10SB / DC10WC / DC10WD / DC18RE
•
Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above.
Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for impact drilling in brick, brickwork
and masonry. It is also suitable for screw driving and drill
-
ing without impact in wood, metal, ceramic and plastic.
Noise
The typical A-weighted noise level determined accord
-
ing to EN60745-2-1:
Sound pressure level (L
pA
) : 82 dB(A)
Sound power level (L
WA
) : 93 dB (A)
Uncertainty (K) : 3 dB(A)
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) deter
-
mined according to EN60745-2-1:
Work mode: impact drilling into concrete
Vibration emission (a
h,ID
) : 13.0 m/s
2
Uncertainty (K) : 1.5 m/s 2
Work mode: drilling into metal
Vibration emission (a
h,D
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
NOTE:
The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE:
The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima
-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
EC Declaration of Conformity
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.