4
11.
Do not point the tool at any one in the area
when operating. The bit could fly out and
injure someone seriously.
12.
Do not touch the bit or parts close to the bit
immediately after operation; they may be
extremely hot and could burn your skin.
13.
Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
USD203-2
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating
current
･
Class II Construction
･
revolutions or reciprocation per minute
･
number of blow
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
1
002889
CAUTION:
•
Before plugging in the tool, always check to see
that the tool is switched off.
•
Switch can be locked in "ON" position for ease of
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, push the switch lever on the left side of
the tool. To stop the tool, push the switch lever on the
right side of the tool.
Speed change
For HM1202C only
1
002897
The blows per minute can be adjusted just by turning the
adjusting dial. This can be done even while the tool is
running. The dial is marked 1 (lowest speed) to 6 (full
speed).
Refer to the table below for the relationship between the
number settings on the adjusting dial and the blows per
minute.
1. Adjusting dial
1. Switch lever
