8
Installing or removing depressed center
grinding wheel/Multi-disc (accessory)
1
2
3
4
006746
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
NOTE:
When using a more than 7 mm thick depressed center
grinding wheel, overturn the lock nut and screw it onto
the spindle.
Super flange
Models GA7020F,GA7020SF,GA9020F and 9020SF are
standard-equipped with a super flange. Only 1/3 of
efforts needed to undo lock nut, compared with
conventional type.
For Australia and New Zealand
1
2
3
010851
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
with its protrusion facing downward (facing toward the
wheel).
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
2
006738
To remove the wheel, follow the installation procedure in
reverse.
Installing or removing abrasive disc (optional
accessory)
NOTE:
•
Use sander accessories specified in this manual.
These must be purchased separately.
1
2
3
010948
Mount the rubber pad onto the spindle. Fit the disc on the
rubber pad and screw the lock nut onto the spindle. To
tighten the lock nut, press the shaft lock firmly so that the
spindle cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
OPERATION
WARNING:
•
It should never be necessary to force the tool. The
weight of the tool applies adequate pressure.
Forcing and excessive pressure could cause
dangerous wheel breakage.
•
ALWAYS replace wheel if tool is dropped while
grinding.
•
NEVER bang or hit grinding disc or wheel onto
work.
•
Avoid bouncing and snagging the wheel, especially
when working corners, sharp edges etc. This can
cause loss of control and kickback.
•
NEVER use tool with wood cutting blades and other
sawblades. Such blades when used on a grinder
frequently kick and cause loss of control leading to
personal injury.
CAUTION:
•
Never switch on the tool when it is in contact with
the workpiece, it may cause an injury to operator.
•
Always wear safety goggles or a face shield during
operation.
•
After operation, always switch off the tool and wait
until the wheel has come to a complete stop before
putting the tool down.
1. Lock nut
2. Abrasive disc
3. Rubber pad
1. Lock nut wrench
2. Shaft lock
1. Lock nut
2. Depressed
center
wheel/Multi disc
3. Inner flange 102
1. Lock nut
2. Depressed
center wheel
3. Super flange
4. Inner flange