5
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Depth adjustment
For model FS4000, FS4200, FS4300, FS4300A,
FS6200, FS6300, FS6300A, FS6300R
1
A
B
009960
The depth can be adjusted by turning the lock ring. Turn it in
"B" direction for less depth and in "A" direction for more depth.
One full turn of the lock ring equals 2.0 mm change in depth.
For model FS4000X, FS4300X, FS6300X
A
B
1
002612
The depth can be adjusted by turning the locking sleeve.
Turn it in "A" direction for less depth and in "B" direction
for more depth. One full turn of the locking sleeve equals
1.5 mm change in depth.
For all Models
Adjust the lock ring so that the distance between the tip
of the locator and the screw head is approximately 1 mm
as shown in the figures. Drive a trial screw into your
material or a piece of duplicate material. If the depth is
still not suitable for the screw, continue adjusting until you
obtain the proper depth setting.
1
1mm
004149
1
1mm
004154
Switch action
1
2
009961
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
NOTE:
•
Even with the switch on and motor running, the bit
will not rotate until you fit the point of the bit in the
screw head and apply forward pressure to engage
the clutch.
Lighting up the lamps
For model
FS4200,FS4300,FS4300A,FS4300X,FS6200,FS6300,
FS6300A,FS6300R,FS6300X
1
009967
1. Locking sleeve
1. Lock ring
1. Lamp
1. Switch trigger
2. Lock button
1. Locator
1. Locator