ASSEMBLING
[3] DISASSEMBLY/ASSEMBLY
[3] -7. Recoil Starter
Assemble the Recoil starter (
Fig. 28, 29
).
Fig. 28
(1) Set the outer end of Spiral spring here firstly and wind it
clockwise till it is completely installed in the Starter case.
Note
: Apply Makita grease N. No.2 a little on
the Spiral spring (Red grease was applied
to it at ex-factory condition).
(3) Pass the new Starter rope through Starter case
and tie the both Rope ends in Starter knob and Reel.
And wind the Rope around Reel two or three times.
Spiral spring
Notch
Reel
(6) Pull the slack rope in the Starter case
and hook it in the notch of Reel.
(4) Fit the projection of Reel to the hook of Spiral spring
while turning Reel clockwise.
Note
: Precisely fit the projection of Reel to
the Spiral spring’s hook by repeating the step (4).
Starter case
Starter case
Reel
Starter knob
Protrusion
of Reel
Mounted Reel
Torsion spring
Hook of Spiral spring
Cam
Set screw
Rope
(5) Fix Torsion spring and Cam
on the Reel with Set screw.
P 1
5
/ 2
6
R
epair
Fig. 29
(7) Hold the rope near by the notch and turn it
with the Reel clockwise to let Spiral spring
have recoil force for driving Reel.
Rope
Reel
(8) Remove the rope from the notch and release your finger from Reel.
The Reel turns counterclockwise. Repeat the actions of (6), (7), (8),
until the Rope is wound by the Reel completely.
Notch
Reel
Rope
