17
12
11
4
3
2
15
8
10
Pull the chain (
8
) around the sprocket nose (
10
) of the guide
bar in the direction of the arrow.
Align hole on sprocket guard (
4
) with the pin (
11
).
Turn the chain tensioner (
3
, see ”Tightening the saw chain”) to
bring the chain tensioner pin (
12
) into alignment with the hole
in the guide bar.
Push the sprocket guard (
4
) onto the pin (
11
).
Tightening the saw chain
Simultaneously push in hard on the sprocket guard quick ten-
sioner (
2
) and turn it clockwise to screw the sprocket guard on,
but do not yet tighten it.
Raise the tip of the guide bar slightly and turn the chain tensioner
(
3
) clockwise until the saw chain is
ß
ush against the bottom of
the guide bar (see circle).
Push the sprocket guard quick tensioner (
2
) in again and tight-
en by turning clockwise.
Release the sprocket guard chain tensioner until it turns freely,
then fold it in between protective ribs (
15
) as shown in the il-
lustration.
Summary of Contents for EA3502S
Page 39: ...39 ...
