Makita DWD181, Instruction Manual

Page: 163 / 195

35
Using the Wall Scanner
Marking with the use of the sensor's right (left) edge line
1. Move the scanner to where the
center of the iron bar detection mark
is aligned with the sensor's right
edge line.
* The sensor's right and left edge lines
on the screen represent the scanner's
both right and left edge lines.
2. Make a marking at the recess on the
scanner's right edge.
The mark represents the center of
the buried object.
1. Recess
Shutdown
Press and hold the power button ( ).
The end screen is shown, and after a few seconds, the power is turned off.
NOTE
• Do not remove the battery until the end screen goes out.
1