P
5
/
1
6
Fig. 5
R
epair
DISASSEMBLING
ASSEMBLING
(4) Remove Cushion from Shaft pipe complete. (
Fig. 5
)
(1) Assemble Pipe rubber, Cushion with Hanger to Shaft pipe complete. (
Fig. 6
)
1. Pull off Pipe rubber, and then loosen
M5x18 Hex socket head bolt.
2. Receive the end of Shaft pipe on wood and tap Cushion
with plastic hammer to remove Cushion and Hanger
from Shaft pipe.
3. After assembling the above parts, adjust their positions as drawn below.
Then, fix Hanger with M5x18 Hex socket head bolt.
M5x18 Hex
socket head bolt
Wood as a
cushion
Hanger
[Motor side]
[Gear case ass’y side]
[Gear case ass’y side]
[Motor side]
Pipe rubber
Hanger
Plastic hammer
Cushion
Hanger
Hanger
1. Set Hanger to Cushion.
Cushion
Pipe rubber
103mm
304 ~306mm
447 ~ 457mm
Fig. 6
Cushion
2. Shaft pipe ends have holes.
Install Cushion with Hanger and Pipe rubber to Shaft pipe complete from
Motor section side so that the long pitch between one end and one hole
faces to Cushion.
[Gear case ass’y side]
[Motor side]
52.5 mm
(Long pitch)
15 mm
(Short pitch)
holes
Hanger
Cushion
Pipe rubber
Shaft pipe complete
[Gear case ass’y side]
[Motor side]
Handle holder
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Shaft pipe complete (cont.)
M5x18 Hex socket head bolt