Makita DUR187U, Original Instructions Manual

Page: 12 / 20

12 ENGLISH
1
► 1. Wire guard
NOTE: Do not expand the wire guard outward too
much. Otherwise it may break.
When wire guard is not in use, lift it for the idle position.
Installing nylon cutting head
Optional accessory
CAUTION:
If the nylon cutting head acciden-
tally impacts a rock or hard object during oper-
ation, stop the tool and inspect for any damage.
If the nylon cutting head is damaged, replace it
immediately. Use of a damaged cutting tool could
result in serious personal injury.
CAUTION:
Make sure to remove the hex
wrench after installation.
NOTICE:
Be sure to use genuine Makita nylon
cutting head.
1
2
3
4
► 1. Nylon cutting head 2. Metal guard 3. Spindle
4. Hex wrench
1. Turn the tool upside down so that you can replace
the cutting tool easily.
2. Insert the hex wrench through the hole on the
motor housing and rotate the spindle until the spindle is
locked.
3. Place the nylon cutting head onto the
threaded spindle directly and tighten it by turning it
counterclockwise.
4. Remove the hex wrench.
To remove the nylon cutting head, turn it clockwise
while holding the receive washer with the hex wrench.
Installing plastic blade
Optional accessory
CAUTION:
If the plastic blade accidentally
impacts a rock or hard object during operation,
stop the tool and inspect for any damage. If the
plastic blade is damaged, replace it immediately.
Use of a damaged cutting tool could result in serious
personal injury.
CAUTION:
Make sure to remove the hex
wrench after installation.
NOTICE:
Be sure to use genuine Makita plastic
blade.