11 ENGLISH
Cutting depth adjustment
After grinding or replacing the shear blades, adjust the
cutting depth. To adjust the cutting depth, follow the
steps below.
1.
Turn on the tool and pull the switch trigger twice to
open the shear blades.
2.
While pulling the switch trigger fully, press and
hold the angle adjustment button for a few seconds until
the green indicator lamp blinks fast.
3.
Adjust the cutting depth by pulling the switch
trigger repeatedly so that the overlap of the tips of the
upper and lower shear blades is 1 to 3 mm.
3
1
2
Fig.8
►
1.
Upper shear blade
2.
Lower shear blade
3.
1 -
3 mm
NOTE:
The upper shear blade returns to the shallow-
est position when you pull the switch trigger after the
upper shear blade reaches the deepest position.
NOTE:
If the tool is overloaded while adjusting the
cutting depth adjustment, the green lamp blinks and
red lamp lights up. In this case, turn off the tool, then
remove the cause of the overload, and then adjust the
cutting depth again.
4.
Press and hold the angle adjustment button to
complete the adjustment. The green indicator lamp
stops blinking and lights up.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When replacing the shear blades,
always wear gloves so that your hands do not
directly contact the shear blades.
Removing or installing the shear
blades
1.
Loosen the bolts with the hex wrench, then slide
the cover slightly and remove the bolts and cover, and
then turn over the tool.
1
2
Fig.9
►
1.
Bolt
2.
Cover
2.
Loosen the bolt with the hex wrench, and then
remove it.
1
Fig.10
►
1.
Bolt
NOTICE:
Do not loosen the nut before loosening
the bolt.
Otherwise, the nut may be damaged.