11 ENGLISH
Changing assist type
This tool employs assist function that offers several
easy-to-use application modes for driving screws with
good control.
The type of the application mode changes every time
you press the button
.
You can change the assist type within approximately
one minute after releasing the switch trigger or press-
ing the button
,
, or the quick mode-switching
button.
1
►
1.
Button
Application mode
(Assist type displayed
on panel)
Maximum blows
Feature
Purpose
Wood mode *1
3,800 min
-1
(/min)
This mode helps to prevent a screw from falling at
the beginning of driving. The tool drives a screw
with low-speed rotation at first. After the tool starts
to impact, the rotation speed increases and reaches
the maximum speed.
Tightening long screws.
Bolt mode (reverse rota-
tion auto stop) *1 *2
3,800 min
-1
(/min)
This mode helps to prevent a bolt from falling off.
When loosening a bolt with the tool driving in coun-
terclockwise rotation, the tool automatically stops
after the bolt/nut gets enough loosened. The stroke
of the switch trigger to reach maximum speed will
become short in this mode.
Loosening bolts.
T mode (1) *1
–
(The tool stops rotating
soon after impact starts.)
This mode helps to prevent the screws from
over-tightening. It also accomplishes quick oper-
ation and good finish at the same time. The tool
drives a screw with high-speed rotation and stops
soon after the tool starts to impact.
NOTE:
The timing to stop the driving varies depending
on the type of the screw and material to be
driven. Make a test driving before using this
mode.
Driving self-drilling
screws to a thin metal
plate with good finish.
T mode (2) *1
2,600 min
-1
(/min)
This mode helps to prevent the screws from
breakage and stripping. It also accomplishes quick
operation and good finish at the same time. The tool
drives a screw with high-speed rotation and slows
down the rotation when the tool starts to impact.
NOTE:
Release the switch trigger as soon as the tight-
ening finished to avoid overtightening.
Driving self-drilling
screws to a thick metal
plate with good finish.
*1 : Automatic speed control works only when the switch trigger is fully pulled.
*2 : Reverse rotation auto stop works only when the tool is driving in counterclockwise rotation.
NOTE:
When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
.
NOTE:
All lamps on the switch panel go out when the tool is turned off to save the battery power. The type of the
application mode can be checked by pulling the switch trigger to the extent that the tool does not operate.
