8 ENGLISH
For DFS251
3 mm (1/8")
1
Fig.9
►
1.
Locator
Adjust the locator so that the distance between the tip
of the locator and the screw head is approximately 3
mm (1/8") as shown in the figures. Drive a trial screw
into your material or a piece of duplicate material. If the
depth is still not suitable for the screw, continue adjust
-
ing until you obtain the proper depth setting.
Hook
CAUTION:
Always remove the battery when
hanging the tool with the hook.
CAUTION:
Never hook the tool at high location
or on potentially unstable surface.
1
Fig.10
►
1.
Hook
The hook is convenient for temporarily hanging the tool.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
For DFS250
1
Fig.11
►
1.
Locator
1
2
3
Fig.12
►
1.
Locator
2.
Driver bit
3.
Magnetic bit holder
To remove the driver bit, pull the locator, and then grasp
the bit with a pair of pliers and pull the bit out of the
magnetic bit holder. To install the driver bit, push it firmly
into the magnetic bit holder. Then install the locator by
pushing it firmly back.
For DFS251
1
Fig.13
►
1.
Locator