Makita DF030D Technical Information Download

Page: 4 / 4

P 4/ 4

iring diagram

Fig. D-2

Fig. D-3

Pay attention to the directions of lead wires and connect Flag receptacles
to electrical parts.
Refer to the following illustration.

Fig. D-4

Before installing Switch in Housing R, route Lead wires as illustrated below and connect two Connectors.
Do not ride their Lead wires on ribs.

Route Lead wires between ribs.

Insert Connectors between
their Lead wire holders.

Bend the terminals of DC motor
as illustrated.

Flag receptacles and
Lead wires have to
be far from DC motor.
Do not ride them
on the ribs.

Lead wires holders

Do not ride Lead wires on their embosses.

Face the glue-attached portion of LED
to DC motor side.

Terminal

DC motor

Connector

Lead wire holders

LED

Lead wires in this area
must be tight.

red marking

Connector

(To Switch)

Summary of Contents for DF030D

Page 1: ...on with variable speed in each range for a wide range of applications Uses new 10 8V Li ion battery of stick type as a power unit The models also includes the accessories listed below in Standard equi...

Page 2: ...ace between two Compression springs 4 on the reverse side of Speed change lever assembly and insert the emboss of the change lever into one of Compression spring 4 Fig 6 Repair P 2 4 2 DISASSEMBLY ASS...

Page 3: ...r Assembly cont ASSEMBLING Fig 9 Fig 8 Fig 7 3 3 Assembling Leaf Spring 3 4 Assembling F R Change Lever 3 2 Disassembling Bit Holder of Gear Assembly Sleeve Ring spring 10 1 While pushing the top of s...

Page 4: ...ot ride their Lead wires on ribs Route Lead wires between ribs Insert Connectors between their Lead wire holders Bend the terminals of DC motor as illustrated Flag receptacles and Lead wires have to b...