1
2
4
5
6
3
A
B
Cleaning the guide bar,
lubricating the sprocket nose
CAUTION: Protective gloves must be worn.
Regularly inspect the bearing surfaces of the guide bar for
damage, and clean them with a suitable tool.
If the saw is used intensively it will be necessary to lubricate the
return sprocket bearings regularly (once a week). To do this, first
thoroughly
clean the mm hole at the tip of the guide bar, and
then press in a small amount of multi‑purpose grease.
Multi-purpose grease and grease guns are available as acces-
sories.
Multi-purpose grease
(order number 944 360 000)
Grease guns
(order number 944 350 000)
Cleaning the sprocket interior, checking and
replacing the chain catch sleeve
CAUTION: Before doing any work on the guide bar or chain,
always switch off the engine and pull the plug cap off the
spark plug
(see „Replacing the spark plug“)
. Always wear
protective gloves!
CAUTION: Do not start the saw until it has been completely
assembled and inspected!
Remove the sprocket guard (
4
) (see section on „PUTTING INTO
OPERATION“ A – B) and clean the interior with a brush.
Remove the chain (
3
) and guide bar (
2
).
NOTE:
Make sure that no residue or contaminants remain in the oil
guide groove (
1
) and the chain tightener (
6
).
For replacing the guide bar, chain, and sprocket see „PUTTING
INTO OPERATION“.
Chain catch sleeve
Visually inspect the chain catch sleeve (
5
) for damage and
replace if necessary.
Remove the sleeve by firmly pulling it upwards and off; then
push on the new sleeve.
